Filter
Top Products
Installation and Operation, cont’d
DVS 204 • Installation and Operation2-20
IR 901 Infrared Remote Control
The IR 901, shown at right, replicates all of the front
panel controls except the Menu and Next buttons. If
Executive mode has been enabled on the DVS 204,
input selection and adjustments can still be made from
the IR 901. You must use the DVS 204’s front panel or
the Windows-based control program (via an RS-232
device) to configure and program the scaler. See
chapter three, “Serial Communication”, for details.
The topmost part of the IR 901 features three Aspect
Ratio Preset buttons, a Freeze button and four input
selection buttons (1, 2, 3, 4). Inputs 5 and 6, and the
Take button are not functional. The middle portion of
the IR 901 features the size and centering buttons. The
bottom part contains the adjustment controls for color,
tint, brightness, contrast, and detail adjustments. The
sharpness buttons are not functional.
Aspect ratio presets
Up to three saved memory presets of sizing and
centering information may be recalled selecting these
buttons. See the “Memory Preset” section earlier in
this chapter.
Freezing an input
To freeze the input being displayed, press the Freeze
On/Off button. To unfreeze the input, press the Freeze
button again.
Selecting an input
To select an input source, press an input button (1 through 4).
Size and center
Use the Size and Center buttons to adjust the sizing and centering aspects of a
displayed image.
Image adjustments
The color, tint, brightness, contrast, and detail of a displayed image may be
increased or decreased by using the appropriate Image Adjustment buttons at the
bottom of the IR 901.
DVS Remote