Filter
Top Products
DA AV EQ Series • Installation and Rear Panel
DA AV EQ Series • Installation and Rear Panel
Installation and Rear Panel, cont’d
2-5
To mount the DA AV EQ under a desk, podium, or table top,
1. If rubber feet were previously attached to the bottom of
the unit, remove them.
2. Remove the two screws from one side of the unit. Retain
the screws for possible later reassembly.
3. Attach one bracket to the side of the unit, using the
provided machine screws.
4. Repeat steps 2 and 3 on the other side of the unit.
5. Hold the DA with the attached brackets against the
underside of the table or other furniture. On the mounting
surface, mark the location of the bracket’s screw holes.
6. Drill pilot holes 1/4" (6.4 mm) deep and 3/32" (2 mm) in
diameter into the table or desk top at the marked screw
locations. The holes should be drilled from the underside
or inside (concealed side) of the furniture where the
amplifier will be located.
7. Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until slightly less
than 1/4" of the screw head protrudes.
8. Align the mounting screws with the slots in the brackets
and place the unit against the surface, with the screws
through the bracket slots.
9. Slide the unit slightly forward or back, then tighten all
four screws to secure it in place.
2-4
Use the 2 mounting holes on
o
pp
osite corners.
(2) 4-40 x 3/16"
Screws
1U Universal Rack Shelf
Front false
faceplate
uses 2
screws.
1/2 Rack Width Front False
Faceplate
Using screws
longer than 3/16” will
damage the unit and
void the warranty.
Mounting a DA AV EQ on a 9.5" deep rack shelf
Furniture mounting
Furniture-mount the DA AV EQ under a desk or shelf using the
optional mounting kit (part #70-077-01), as illustrated below.
Under-desk mounting the DA AV EQ