Filter
Top Products
Specifications
AMPLIFIER section
Output Power: 2.0 W + 2.0 W
Frequency Response: 60 TO 20, 000 Hz
TUNER section
FM Section Frequency Range:
88 to 108 MHz
AM Section Frequency Range
530 to 1710 KHz
CD PLAYER section
Frequency Response
60 to 20, 000 Hz +/-4 Db
Signal-to-Noise Ratio 55 dB (IEC-A)
RECORD PLAYER section
Motor DC servo motor
Drive System Belt Drive
Speeds 33-1/3 rpm, 45 rpm and 78 rpm
Flutter Less than 0.25% (WTD)
S/N Ratio More than 50 dB
Cartridge Type Ceramic Stereo
Cartridge Stylus 402-M208-165
Output Level 160-380 mV
(5 cm/sec at 1 KHz)
SPEAKER SYSTEM section
Type 1-way
Impedance 8 ohms Input
Power Max. 5
GENERAL
Power Requirements AC 120 V~ 60 Hz
Power Consumption 19 W
Dimensions 18'' x 13.2''x 9.6'' (approx.)
Weight 18 Ibs. (approx.)
Users Guide
45 RPM Adapter
12 13
6. Press the FF (UP) button to
skip ahead to the next track or to
scroll quickly through the cur-
rent track.
NOTE: Do not push both FF
(UP) and FW (DOWN) buttons
together as this may damage the
unit.
When using FF (UP) and FW
(DOWN) buttons forward or
reverse you will hear your selec-
tion playing at a distorted
speed. See Figure 10. Simply
release the FF (UP) or FW
(DOWN) buttons to continue
playing at normal speed at the
desired position of the CD.
7. Press the FW (DOWN ) but-
ton to go back to the previous
track or to scroll quickly back-
wards through the current track.
8. To replace or remove a CD,
press down on the center of the
CD lid and carefully lift the CD
out. Carefully hold the CD by the
edge to avoid fingerprints.
Precautions:
If the CD is scratched, dirty,
or in-correctly placed on the
disc tray, it may not play prop-
erly.
Bear in mind the following
points since any dirt; scratches
or warping
of the disc
can cause
broken or
intermittent
sound and
noise.
When holding the discs, take
care not to touch the playing
surface.
Do NOT
place discs in
the following
locations:
• Near a heating device or
place where the temperature is
high;
• In damp or dusty areas.
Wipe away any fingerprints
or dust on the playing surface
of the disc using a soft cloth.
Always wipe from the inside
toward the outside of the disc.
Return your CD to its case
after use to avoid serious scratch-
es that could cause the laser pick
up to skip.
Do NOT expose any CDs to
direct sunlight or high humidity
and temperature for any extended
periods.
Do NOT stick paper or write
anything with a ballpoint pen on
the surface of the label side.
Do NOT use irregular shaped
CD’s (octagonal, heart-shape,
etc.), all of which can damage the
unit.
Do NOT switch the unit off
while playing a CD – this will
damage the unit.
FIGURE 10: When using FF (UP) and
FW (DOWN) buttons forward or reverse
you will hear your selection playing at
a distorted speed.
FF (FA
ST
FORWARD)
FW
(R
EWIND)