Filter
Top Products
10
Traveler II Digital G8 OWNER’S MANUAL
11
Traveler II Digital G8 OWNER’S MANUAL
SETTING THE CLOCK
The clock functions in 24 hour mode only, not in 12 hour, AM, PM time.
1. Set the time zone selector onto your home time zone.
2. Press the HOME/WORLD button for about two seconds and notice that
the HOME time hour in the display ashes.
3. While it’s ashing, set the HOME hour with the tuning knob.
4. While it’s still ashing press the HOME/WORLD button once more and
notice that the HOME minutes in the display ash.
5. While it’s ashing, set the HOME minutes with the tuning knob.
6. While it’s ashing, press the HOME/HOUR button to complete the setting.
SETTING THE ALARM TIME
1. With the radio turned off, press the ALARM button (bottom right under
ip cover) for about two seconds and notice the alarm hour ashing in
the display’s upper right corner.
2. While it’s ashing rotate the tuning knob to set the hour, then press the
ALARM button again to make the minutes ash.
3. While they’re ashing rotate the tuning knob to set them, then press the
ALARM again to make the SLEEP indicator ash in the upper left corner
of the display.
4. While it’s ashing press rotate the tuning knob to set the amount of time
that the alarm stays on (from 1-90 minutes).
5. Press alarm again to nalize the setting.
Note: Alarm is activated according to your world time clock; unless, you
have rotated the time zone selector back to your home time zone.
SWITCHING THE ALARM ON/OFF
With the radio turned on or off, press the ALARM button with quick, short
presses, over and over, noticing that a speaker or a bell appears under the
box labeled ‘Timer’ in the upper left corner of the display.
Leave the speaker there if you want the speaker alarm to turn the radio on;
leave the bell if you want to wake up to a beeper. Leave it blank, with no
speaker or bell if you do not want the alarm.
SNOOZE/LIGHT/LOCK BUTTON
When your alarm functions and SNOOZE is pressed, it allows you to sleep for
5 more minutes, then the alarm sounds again.
Pressing the LIGHT button turns the light on for about 10 seconds.
Pressing LOCK with the radio off locks all buttons. This can keep the radio
from accidentally turning on.
DISPLAY BUTTON
Pressing the DISPLAY button sequentially with the radio off shows the
temperature, world time and alarm time in the upper right corner of the
display. Pressing it sequentially with the radio on shows home time, world
time, signal strength measured in dBu and dB, alarm time and temperature.
Press and hold the LOCK button for 2 seconds, the radio will on locks all
buttons. This keeps the radio from being accidentally being turned off or
stations from being changed. Press and hold the LOCK button again to
unlock it.