12
Remote Control Unit
Notes on use
< Point the remote control unit at the main unit’s remote sensor
within seven meters (23 feet) of the main unit. There should
not be any obstacles between the player and the remote
control unit.
< Do not allow direct sun or other light to shine on the remote
sensor part of the main unit. This may cause the remote
control unit to work incorrectly.
< Note that other units with remote controls may operate
incorrectly because of infrared light “overspill” when you
operate this remote control unit.
How to insert the batteries
Remove the cover of the remote control unit with a Philips
screwdriver. After checking the polarity (
+/_) of two AA
batteries, insert the batteries, replace the cover and replace
the screws.
Battery Replacement
If the distance required between the remote control unit and
main unit decreases, the batteries are exhausted. In this case
replace the batteries with new ones.
Precautions concerning batteries
< Be sure to insert the batteries with correct positive “+” and
negative “
_” polarities.
< Use batteries of the same type. Never use different types of
batteries together.
< Rechargeable or non-rechargeable batteries can be used but
not mixed together. Refer to the precautions on their labels.
< When the remote control unit is not to be used for a long
time (more than a month), remove the batteries from the
remote control unit to prevent them from leaking.
< If the batteries leak, wipe away the liquid inside the battery
compartment and replace the batteries with new ones.
Press the POWER button to turn the unit on.
The indicator ring lights in blue.
If the indicator ring is red, press the ON button of the remote
control to turn the unit on (page 11).
Press the OPEN/CLOSE button (L) to open the tray.
The tray opens toward to you.
Insert the disc label side up.
< Make sure the disc is clean, free from scratches and is
centered in the tray in order to avoid any malfunction or
jamming of the tray or damage to the disc.
Press the OPEN/CLOSE button (L) again to close the
tray.
The tray will close. Be careful not to catch your fingers in the
tray.
< The unit then reads the disc (this may take a little time as the
mechanism loads and clamps the disc).
Press the PLAY button (y) to start playback.
During the play mode, the indicator ring of the PLAY button
(
y) lights in blue.
5
4
3
2
1
1 3 54
2
Playback (1)