Esoteric I-03 Stereo Amplifier User Manual


 
6
Identifying the Parts (Remote Control Unit)
The buttons not mentioned in this chapter do not work with the I-03.
However, they can be used for other Esoteric products.
a
ON (confirm settings)
Some settings can be changed using this button in “Additional
settings” (pages 16, 18).
You can also assign names to the terminals using this button
(page 18).
o You can not turn the power on or off using this button.
b
INPUT (</>)
Press these buttons to select a source. Select the input terminal
that is connected to the device that you want to play (page 12).
In setup mode, press these buttons to change the setting of each
item (pages 14, 15).
c
DIMMER
Use this button to select one of four brightness levels for the
display and indicator lamps (page 13).
d
SETUP
Press this button to enter the setup mode for balance and output
level adjustments (page 14).
Press this button for more than 2 seconds to enter additional
setup modes (page 15).
e
CLEAR
In setup mode, use this button to exit the setup mode (pages 14,
15).
f
VOLUME (
+
/
)
Use these buttons to adjust the volume.
o When you set the RCA2 terminals to “THRU” (page 16), or when
you set the PRE OUT terminals to “REC” (page 16), the VOLUME
control buttons do not work.
g
MUTING
Press this button to mute the sound. Press this button again to
restore the sound (page 13).
a
b
f
c
d
e
g
To simplify explanations, instructions in this manual might refer to
the main unit or remote control unit only. In such cases, the same
controls on the remote control and main unit will operate similarly.