Filter
Top Products
9
ENGLISH
Analog audio output terminals
Use either the XLR or RCA (pin) FRONT terminals for analog
stereo output.
If your amplifier has balanced XLR analog audio inputs,
connect the XLR jacks on the unit to the amplifier’s XLR
jacks, otherwise use the RCA (pin) connections.
For surround (5.1) amplifiers with analog inputs, also use the
RCA (pin) SURROUND pair, CENTER and SUBWOOFER
connections (in addition to the FRONT pair).
<
If you are connecting only 2 channels, use the 2CH/MULTI
button on the remote control to select “2 ch”. For surround
sound with six speakers connected, you can select either
“2ch” or “5.1 ch” mode. Note that if multi-channel
program material is played and 2-channel mode is selected,
the multi-channel material will be downmixed to two
channels, and output through the L and R front outputs.
Digital audio output terminals
The unit may be connected using either coaxial or optical
(TOS) commercially available cables to amplifiers or to digital
audio devices such as CD recorders, etc.
COAXIAL: Use RCA (pin) digital audio cable
OPTICAL: Use optical digital audio cable (TOS)
<
The optical terminal is covered by a shutter. Make sure that
the cable is firmly inserted, but do not force the cable when
connecting it or removing it, in order not to cause damage
to the unit.
B
A
Application notes
The unit does not output digital surround sound from Super
Audio CDs, so to enjoy surround sound from these media, you
must make analog connections to a suitably equipped
surround sound amplifier.
Word sync connector
This allows the use of an externally-generated word clock
connection, using a commercially available BNC coaxial
cable.
Devices producing such a suitable clock signal include
external D-A converters, or dedicated word clock
generators. Connect the SYNC OUT (or WORD OUT) of such
a device to the unit.
Digital output expansion slot
This slot is reserved for a future upgrade, which will allow
the output of Super Audio CD data in digital format.
SIGNAL GND connection
Use a commercially available PVC-covered cord to connect
the signal ground terminal on the unit to the amplifier signal
ground.
<
Note that this is NOT an electrical safety ground (earth).
Power cord receptacle
After all other connections have been made, insert the
supplied AC power cord into this receptacle, then connect
the other end of the power cord into the wall socket. Ensure
that your AC voltage corresponds to the voltage marked on
the rear panel of the unit. Consult a qualified electrician if
you are in doubt.
<
In order to avoid the risk of electric shock, fire, and so on,
only use the supplied power cord.
<
If you are not going to use the unit for some time,
disconnect the power cord from the wall socket.
F
E
D
C