Filter
Top Products
SETTING THE CONDITIONS
DIP switch settings
The C82303* interface board has a set of DIP (Dual In-line
Package) switches, and 6 jumpers. This switch and jumpers
are used for selecting various interface operations.
Before you install the C82303* interface, you may need to
adjust some of the settings. When making DIP switch setting
changes, it is best to use a pointed device, such as a ball-point
pen
or small screwdriver.
Board layout
The diagram below shows the layout of the C82303* board,
and the locations of the DIP switch and jumpers.
Figure 1. Board layout
Caution
All changes of DIP switch and jumper settings should be made
with the printer power turned off. The printer checks and
recognizes new settings only at the time the power is turned
About DIP switches
A set of DIP switches on the C82303* is labelled SW1. SW1
contains a number of individual toggle type switches that can
be set either on or off. The individual switches are referred to
by set (SW1) and number. Therefore, the switch in set SW1
marked by the small number 3 is called DIP switch 1-3.
5