Epson C82303* Stereo System User Manual


 
FCC COMPLIANCE STATEMENT
FOR AMERICAN USERS
This equipment has been tested and found to comply with the limits for a Class B digital device.
Pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful Interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However there is no guarantee that
interference Will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
-
Reorient or relocate the receiving antenna
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-
Consult the dealer or an experienced radio/TV technician for help
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1)
this device may not cause harmful interference. and
(2)
this device must accept any interference received,
including interference that may cause undesired operation.
FOR CANADIAN USERS
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital
apparatus as set out in the radio interterence regulations of the Canadian Department of
Communications.
Le
pr6sent
apparelI
numerique
“‘Pm&
pas
de
bruits
radioClectriques
depassant
les
limites
applicables
aux
appareils
numdnques
de
Class
B
prescrites
dam
lr
rGglrment
SW le
brouillage
radi&lectrique
edict6
par
le
Minis&w
des
Commumcatmns
du
Canada.
WARNING
The connection of a non-shielded printer interface cable to this printer will invalidate the FCC
Certification of this device and may cause interference levels which exceed the limits established
by the FCC for this equipment. If this equipment has more than one intertace connector. do not
leave cables connected to unused interfaces.
Seiko Epson Corporation shall not be liable against any damages or problems arising from the use
of any options or any consumable products other than those designated as Original Epson
Products or Epson Approved Products by Seiko Epson Corporation.
NOTICE
All rights reserved. Reproduction of any part of this manual, in any form whatsoever without Seiko
Epsons express written permission is forbidden.
The contents of this manual are subject to change without notice.
All efforts have been made to ensure the accuracy of this manual. However. should any errors be
detected, Seiko Epson would greatly appreciate being informed of them
The above notwithstanding, Seiko Epson can assume no responsibility for any errors in this
manual or their consequences.
Copyright © 1989 by Seiko Epson Corporation. Nagano. Japan
32KB Parallel Interface
32-KB-Schnittstellenkarte
Interface parallsle 32Ko
Interface en paralelo de 32KB
Interfaccia parallela da 32 KB
i