Filter
Top Products
22
Normal Playback
1.) Press the POWER/STANDBY button to turn the system ‘On’.
2.) Press the CD button on front panel or CD/TUNER button on remote control to
select CD function.
3.) Press the OPEN/CLOSE button on front panel to open the CD door. Remove
the “dummy CD” transit protection cards and discard it. You cannot play your
own CD unless the card is removed.
4.) Load your own CD into the player with the printed ‘label’ facing out.
Gently press on the CD near the center hole to insure that the disc is properly
‘seated’ on the spindle.
5.) Press the OPEN/CLOSE button to close the CD door.
The display flashes as the player reads the
Table Of Contents on the disc.
After reading the disc the display will show the
total tracks and playing time.
Note: The reading time may be longer if you are using CD-RW (rewritable)
discs. This is normal and not an indication of any problem with your unit.
6.) Press the PLAY/PAUSE button to begin
playback.
7.) Adjust the VOLUME and EQ controls as desired.
8.) Playback will continue until all tracks on the disc have been played, then the
player stops and the display shows the total tracks number and playing time on
the disc.
ES30_072905.p65 29/7/2005, 16:4122