Filter
Top Products
4
PREPARATION FOR USE
Protect Your Furniture
This model is equipped with non-skid rubber 'feet' to prevent the product from
moving when you operate the controls. These 'feet' are made from non-migrating
rubber material specially formulated to avoid leaving any marks or stains on your
furniture. However certain types of oil based furniture polishes, wood preservatives,
or cleaning sprays may cause the rubber 'feet' to soften, and leave marks or a
rubber residue on the furniture. To prevent any damage to your furniture we strongly
recommend that you purchase small self-adhesive felt pads, available at hardware
stores and home improvement centers everywhere, and apply these pads to the
bottom of the rubber 'feet' before you place the product on fine wooden furniture.
Unpacking and Set Up
• Carefully remove the unit from the carton and remove all packing materials
from the unit.
• Carefully remove any small strips of tape which may have been used to keep
the CD door closed during shipment.
• Open the CD compartment by lifting the “OPEN/CLOSE” tab on right side of
CD door. Inside the CD compartment you will see a white transit card which is
used to prevent the laser pick-up from moving during shipment. Carefully
remove this card and close the CD compartment door.
• Please save the carton and packing materials in the event that your unit ever
needs to be returned for service. The original carton and packing materials are
the only way to protect the unit from damage during shipment.
• Unwind the FM lead wire antenna and extend it to its full length.
• Remove the twist-tie from the AC power cord and extend it to its full length.
MS7618R_062205.p65 22/6/2005, 15:094