Filter
Top Products
20
TEST TONE, LFE TRIMMER & CHANNEL SELECT
TEST TONE
Speaker Level balance Adjustment
The test tone function is useful to adjust the relative volume between
speakers in DOLBY DIGITAL or DOLBY PRO LOGIC II mode.
Once the balance is set, you don’t have to change the balance as
long as the speakers aren’t moved.
1. Adjust the MASTER VOLUME to the normal listening level. (Half
of max. Volume is recommended)
2. Press the TEST TONE button (on the remote control) in DTS,
Dolby Digital or Dolby PRO LOGIC II mode.
The test tone is emitted from each speaker each time you press
“TEST TONE”.
→L(FRONTLEFT)→R(FRONTRIGHT)→LS (SUR. LEFT)
← SUB ← C (CENTER) ← RS (SUR. RIGHT)
3. Select a speaker by pressing the “TEST TONE” button and
adjust the level by pressing the MASTER VOLUME button.
The level of each speaker can be adjusted in 1 dB step from –10
dB to +10 dB.
4. When the setting is finished, press the TEST TONE button to
stop the test tone. (Note: You must keep press TEST TONE until
one complete cycle is finished.)
LOW FREQUENCY EFFECT
LFE (LOW FREQUENCY EFFECT) MIX LEVEL (LFE MIX)
initial setting: 0 dB
Under COAX./OPT mode, when playing a Dolby Digital or DTS
5.1CH signal, LFE will appear on the display. Press the LFE key on
the remote and press the VOL +/- button to adjust the level between
0dB to –10dB. (Note: The LFE adjustment function will resume to
normal, if the VOL +/- button is not pressed within 5 seconds.)
CHANNEL SELECT
Balancing volume between speakers in 5.1 channel mode when
using the 5.1 analogue inputs.
As the Dolby Digital signal is decoded in the external source,
sometimes, you may have to balance volume between speakers due
to the location of speakers. In this case:
1. Press “CH SELECT” on the remote, the following loop will
appear on the display:
→ L(FRONT LEFT)→R (FRONT RIGHT)→LS (SUR. LEFT)
← SUB ← C (CENTER) ← RS (SUR. RIGHT) ←
2. Adjust the Master Volume to balance all speakers.
The level of each speaker can be adjusted in 1 dB steps
from –10 dB to +10 dB.
(Note: If the Master Volume is not adjusted for 5 seconds in
Channel Trimmer state, it returns to normal state.)