Filter
Top Products
15
REMOTE CONTROL INFORMATION
1. Power
Push this button to turn the unit into standby mode, push it again to turn off the unit.
2. Mute
Press this button to mute the sound, push again to cancel the mute function.
3. Input Mode
Select Coaxial, Optical or Analog Input mode in DVD, AV1 and AV2.
4. Dimmer
Press this button to set the brightness of the front panel display.
5. Display
Press this button to display the state of input source. And when listening to the FM broadcasting with RDS, press this button to show
PS, PTY, RT and RT.
6. Input Selector buttons
7. Memory
Press it to store the broadcast station as a preset.
8. PTY Search
In FM state, press this button, the current program type appears on the display, using TUNING +/- to select the program type you
desire.
9. Station +/-
Press these buttons to select a preset channel during the tuner mode.
10. APS
Allocates and memorizes radio stations automatically. (Note: Hold this button down for more than 3 seconds to activate
11. Tuning buttons
- Tuning +/-: Tuner frequency up and down.
- Band: Press this button to alternate between FM and AM.
- Auto/Manual: This button is used to select AUTO or MANUAL tuning for AM and FM stations. Press once to set to AUTO again for
MANUAL.
- ST/Mono: Press this button to alternate between Stereo and Mono mode when listen to FM broadcast.
12. SUB On/Off
Push this button to turn on or off the subwoofer output.
13. Test Tone
To balance speakers in Dolby Digital or Dolby Pro Logic mode.
14. CH Select
Select channels by pushing this button, then use volume key to balance speakers.
15. Volume +/-
Press these buttons to decrease or increase the volume.
16. Bass
Press this button for Bass adjustment, then press +/- key to adjust the level.
17. +/-
These keys are used for SPK SETUP and DELAY TIME, Treble and Bass adjustment.
18. Treble
Press this button for Treble adjustment, then press +/- key to adjust the level.
19. Delay Time
Press this button to set the delay time for the Dolby digital/Dolby Pro Logic modes.
20. Bass Mode
Press this button to set the delay time for the Dolby digital/Dolby Pro Logic modes.
Select one of the two preset speaker configuration according to your speakers. (refer to page 17)
21. Stereo
With the unit in the STEREO mode, only front left and front right speakers and Woofer are working.
22. LFE Trim
Under the Pro Logic 5.1CH or DTS 5.1CH mode, press this button and adjust the volume to set the Low Frequency output level
23. Surround Mode
Select surround modes: MOVIE and MUSIC.
24. Dolby Pro Logic II
When receiving Analog/digital PCM signal or 2CH Pro Logic, turn on this button then the playing is under analog 5.1CH state.
25. Dynamic
Press this button repeatedly to reach your desired compression dynamic range.
26. DTS/Dolby Digital
When playing 5.1CH source, and while you are enjoying Stereo, push this button to playback source in DTS/DOLBY DIGITAL.