Filter
Top Products
Pre-setup with Cinénova Grande
6
Earthquake Sound
7
Confirm the voltage setting of the amplifier. It must match the voltage in your
home. The amp is set by factory to either 120V or 240V. Check above the
circuit breaker for this information.
Getting Started with the Cinénova Grande
5) PLUG IN POWER CORD 6) TURN ON CIRCUIT BREAKER
3) SPEAKER CONNECTIONS
1) INPUT SELECTION 2) X-OVER MODE SELECTION
Set the input control to either RCA or XLR.
This tells the amp which input type will be
used.
A pair of binding posts is
provided for each
channel. These posts
accept bare wire, spade
lugs & banana type
plugs. If bare wire is
us e d th e n, str i p
approximately 1/2 inch
to 3/4 inch of insulation
from the end of each
wire and carefully twist
the strands of each
conductor together.
Then insert.
If you plan to power the
Cinénova using an
external source, then
you will need to plug the
source into the 12VDC
Trigger.
When using this feature
the main power switch
must remain in the OFF
position at all times.
The Cinénova Grande houses 5 or 7
amplification blocks. Each block comes with a
3-way Mode Selection switch. Generally the
amplifier Is used in By Pass mode and fed a
crossed signal from a processor. Unless
otherwise desired, the crossover switch
should remain in Bypass position.
Plug the AC power cord
into the amp first then
into the wall outlet.
Make sure it is firmly
connected.
This amp is equipped
with a 20 ampere circuit
breaker. Once that all
tasks have completed
then proceed to turn the
circuit breaker to the on
position.
4) 12VDC WHEN APPLICABLE
Amplification Block Plate
Power Plate
2
3
1
3 Handles.
The front handles may be removed. The cover must come off
first. You will need a 3mm hex driver for the front mounted
screws.
CAUTION: Be sure that what ever is used to mount this amplifier
on, is extremely strong and durable.
Cinénova Grande Front Panel Overview
Cinénova Grande Front Panel
Cinénova Grande Power Amplifiers
2 3
LR RR
Five Channel Power Amplifier
LF CENTER RF
Cinénova
Grande
Power
1
1. Master Power Switch:
Turns the current to the amplifier ON or OFF manually. When
turning on the amplifier via a 12VDC source the switch must be in
the OFF position.
Additionally when adding or removing 12VDC connections or
any other connections the main power circuit breaker needs to
be in the off position. This will help prevent any surges that could
damage your products or cause bodily injury.
2 Peak LED Indicators:.
The Cinénova Grande is equipped with five or seven LED
indicators on the front panel that should remain unlit. These
LEDs indicate the operating status of each corresponding
channel. If an LED or all LEDs remain lit continuously, the
amplifier is clipping that channel and the volume should be
turned down immediately to prevent damage. Its ok for the LED
to flicker but it should never remain on continuously.
6
5
4