Earthquake Sound Cinenova 5 Stereo Amplifier User Manual


 
11
10
Each channel - monaural block - of the Cinénova Grande
amplifiers comes equipped with a fully buffered variable filter
(range: 20 Hz to 5000 Hz). Once a crossover point is selected, the
block can be run in low pass or high pass configuration, simply by
a flick of a 3-way switch; the filter can be bypassed by setting the
switch to the full range position.
0.0
-3.0
-6.0
+3.0
+6.0
55Hz
LEVEL IN DECIBEL
LOW PASS
HIGH PASS
Knob In 9 O'clock
Position
Filter @ 55Hz
0.0
-3.0
-6.0
+3.0
+6.0
360Hz
LEVEL IN DECIBEL
LOW PASS
HIGH PASS
Knob In 12 O'clock
Position
Filter @ 360Hz
0.0
-3.0
-6.0
+3.0
+6.0
20Hz
LEVEL IN DECIBEL
LOW PASS
HIGH PASS
Knob In Min
Position
Filter @ 20Hz
0.0
-3.0
-6.0
+3.0
+6.0
5kHz
LEVEL IN DECIBEL
LOW PASS
HIGH PASS
Knob In 3 O'clock
Position
Filter @ 5kHz
REFER TO THE FOLLOWING ILLUSTRATIONS FOR FILTER SETTING:
Cinénova Grande 5 or 7 Filter Settings
Adjusting The Filters
Earthquake Sound
Pre-setup with Cinénova 7
Cinénova 7 Power Amplifiers
Confirm the voltage setting of the amplifier. It must match the voltage in your
home. The amp is set by factory to either 120V or 240V. Check above the
circuit breaker for this information.
Getting Started with the Cinénova 7
1) INPUT SELECTION
Set the input control to either RCA or XLR.
This tells the amp which input type will be
used.
Amplification Block Plate
Power Plate
4) PLUG IN POWER CORD
Plug the AC power cord
into the amp first then
into the wall outlet.
Make sure it is firmly
connected.
2) SPEAKER CONNECTIONS
A pair of binding posts is
provided for each
channel. These posts
accept bare wire, spade
lugs & banana type
plugs. If bare wire is
us e d th e n, str i p
approximately 1/2 inch
to 3/4 inch of insulation
from the end of each
wire and carefully twist
the strands of each
conductor together.
Then insert.
If you plan to power the
Cinénova using an
external source, then
you will need to plug the
source into the 12VDC
Trigger.
When using this feature
the main power switch
must remain in the OFF
position at all times.
3) 12VDC WHEN APPLICABLE
2
1
4
3
The fuse holder is located directly under the power
socket. It contains one extra 15 ampere, 250V fuse.
To access the fuse holder, make sure your
Cinénova is turned off and unplugged from both the
wall outlet and the amplifier’s power socket. Place a
flat head screwdriver in the groove on the top of the
fuse holder and simply pry off the fuse holder.