Filter
Top Products
XDVD8181 OPERATION
48
Troubleshooting
Problem Cause Action
Unit will not turn on
(no power)
Yellow wire not connected or incorrect voltage
Red wire not connected or incorrect voltage
Check connections for proper voltage (11~16VDC)
Black wire not connected Check connection to ground
Fuse blown Replace fuse
Unit has power
(but no sound)
Speaker wires not connected Check connections at speakers
One or more speaker wires touching each
other or touching chassis ground
Insulate all bare speaker wires from each other and chassis
ground
Unit blows fuse
Yellow or red wire touching chassis ground Check for pinched wire
Speaker wires touching chassis ground Check for pinched wire
Incorrect fuse rating Use fuse with correct rating
Unit has audio
(but no video)
Parking brake safety circuit not connected
Parking brake not applied
Check connections at parking brake
Apply parking brake
No video display
(when in reverse)
Reverse circuit not connected
Vehicle is not in reverse
Rear view set to OFF
Check connections at reverse lamp
Select reverse gear
Set rear view to ON - see page 14 for details
DVD does not start playback
Physical defect in media
Wrong region
Check media for scratches
Use discs labeled "Region 1" or "All" only.
IR remote does not work
Dead battery Replace battery
Excessive skipping
Unit is not mounted correctly
Check mounting sleeve
Physical defect in media Check media for scratches
ERR-DISC appears
on display
Focus error or disc is in upside down Press eject or RESET
Region code error appears
on display
Region code error Use only DVDs labeled “Region 1” or “All” only.
Front panel will not
open/close
Front panel obstructed Remove the obstacle and press OPEN again to resume the
monitor open/close sequence.