DTS DTS-6 Home Theater System User Manual


 
3
DTS-6/6D System Test
Tools Required
** RTA (real time analyzer) and pink noise card. Necessary to adjust EQ in “B” chain.
** SPL meter
Projector Speed Disc (special order from DTS)
DTS Technician’s Kit:
6-Track SETUP Disc, Rev. DS1
Used to adjust DTS-6D levels, check automatic default switching, and verify operation of drives & player.
“Buzz and Bill Show” Disc (dated Feb. 1, 1999)
DTS Demo Film, 35mm
Used with the DTS Demo Film to test the DTS system. Used with the “Buzz and Bill Show” disc.
DTS Empirical Test Disc (dated June 7, 1997)
Used to test the theater’s sound system
NOTE
** These items are not supplied by nor are available from DTS.
All tests should be preformed with no audience in the theater.
Test Procedure
1. Before testing the DTS system, check and adjust the theater cinema processor’s B-chain. This must
be checked first. All level adjustments should be made with master fader set to “7”.
Remember, any changes to the B-chain will effect the DTS system.
2. Be sure the rear panel AC voltage switch is properly set for your main AC supply rating. Power on
the DTS player and remove any discs.
3. Sync. Thread up the DTS demo film and use its special leader to calculate the offset. Verify this
matches the OFFSET setting (delay) on the DTS player.
4. Insert the Setup Disc into the DTS player. You may use either the RevC or DS1 Setup Disc. The
player should easily accept the DTS disc. Once the DTS player boots up, it should automatically
switch the cinema processor to the correct format and tone/pink noise should be heard in the theater.
5. Set DTS levels. Open the screen curtains and ensure master fader is set to “7”. Take SPL meter into
the theater and stand off-center in the rear third of the theater. SPL readings should be measured
unweighted, or C weighted - slow. Verify all output levels are as noted below. Do NOT point the
sound pressure level meter out of the porthole window, this will not give you correct SPL readings.
SPL
Left channel PINK noise 85dB
Left surround
PINK noise high passed at 80Hz 82dB
Center channel PINK noise 85dB
Right surround
PINK noise high passed at 80Hz 82dB
Right channel
PINK noise 85dB
Sub bass channel PINK noise low passed w\DTS filter 91dB