Filter
Top Products
SPECIFICATIONS
19
© 2002 Directed Electronics, Inc
1500 watts
0.8% THD
Viper model d2500.1
Signal-to-Noise Ratio Greater than 80 dB
Frequency Response 20-250 Hz +0, -1 dB
Damping Factor 50 (typical)
Crossover Low-pass 24 dB/octave,
variable from 30 to
250 Hz
Subsonic Filter Switchable 24 dB/
octave, variable from
20 to 250 Hz
Bass Equalization Variable 0 to +12 dB,
centered at 40Hz
Input Impedance 20K ohms
Input Sensitivity Variable from 150 mV
to 8 volt
Output Impedance 2 to 4 ohms
Supply Voltage 10 to 16 VDC
Fusing and Power 200A
Minimum Cable Requirements (AWG) (+) 12 Volt #0 Battery to fuse block
(Per amp, trunk mounted) #4x2 Fuse block to
amplifier
Minimum Cable Requirements (Ground) #4x2 Amplifier to chassis
2700 watts
2500 watts
1.0%
THD
RMS continuous power driven into 4 ohms from 20 to 250
Hz @ 14.4 VDC at rated power/load.
RMS continuous power driven into 2 ohms from 20 to 250
Hz @ 14.4 VDC at rated power/load.
Dynamic power rating (IHF-202 Standard) minimum load.