Filter
Top Products
Using other functions
21
ENGLISH
Using other functions
10 SEC (Set upon purchase):
The display automatically turns off after approximately 10 seconds.
CONTINUE:
Displayed continuously.
Setting the low-power standby mode
Setting the time display time in the standby mode
Use 8 or 9 to select “10SEC” or
“CONTINUE”, then press [MENU/SET].
Use [MENU/SET] to select “TIME DISPLAY”.
2
1
ON (Set upon purchase):
Low-power standby mode.
OFF:
Normal mode.
Setting the low-power standby mode (Eco mode)
Use 8 or 9 to select “ON” or “OFF”, then
press [MENU/SET].
Use [MENU/SET] to select “ECO MODE”.
2
1
See page 13 for information on the power indicator.
ENGLISH
Use 8 or 9 to select “ON” or “OFF”, then
press [MENU/SET].
Making the speaker settings
2
1
This procedure can be used to set the optimum sound quality for your
speakers and the installation conditions in your room.
Use [MENU/SET] to select “SPK OPTIMISE”.
ON WALL:
Set this when the speakers are installed on a wall or when there is
a wall directly behind them.
ON SHELF
(Set upon purchase):
Set this when using the included speaker stand.
Setting the speaker locations
Use 8 or 9 to select “ON WALL” or “ON
SHELF”, then press [MENU/SET].
Use [MENU/SET] to select “SPK LOCATION”.
2
1
Set the locations in which the speakers are installed.
This cannot be set when “SPK OPTIMISE” is set to “OFF”.
Setting the speakers low bass sound
ON (Set upon purchase):
This is the optimum setting for the SC-S81 (the speaker included
with the S-81). (We recommend using this setting normally.)
Set this according to the speakers being used.
LOW:
Set this when the reverberations in the room are too weak (when
there is not enough treble sound).
MID
(Set upon purchase):
Set this when the reverberations in the room are moderate.
Making the room damping setting
Use 8 or 9 to select “LOW”, “MID” or
“HIGH”, then press [MENU/SET].
Use [MENU/SET] to select “ROOM DAMPING”.
2
1
Set this according to the level of the reverberations in the room.
This cannot be set when “SPK OPTIMISE” is set to “OFF”.
HIGH:
Set this when the reverberations in the room are too strong (when
there is too much treble sound).
OFF:
Set this when using speakers other than the ones included. (For
directions and cautions on connecting the speakers, see “Speaker
connections” ( page 8).)