Filter
Top Products
ENGLISH
2
Main features
High quality amplifi er stressing sound quality
Equipped with a 30 W + 30 W (6 Ω) high-quality amplifi er circuits.
Direct Play for iPod
®
and iPhone
®
via USB
Music data from an iPod can be played back if you connect the
USB cable supplied with the iPod via the USB port of this unit, and
also an iPod can be controlled with the remote control for this unit.
Weight and Dramatic sound
The board and circuit confi guration has been redesigned to achieve
lower impedance. Since stable current is supplied to the power
amp and other sections, it is possible to realize as much as 30
watts of power.
“Simple & Straight” circuit design for sound
purity and free of coloration
DENON’s popular M series gives you high sound quality based on
the “simple & straight” concept. Circuitry is uncomplicated, signal
paths are short, and all adverse infl uences on sound quality have
been minimized.
Playback of MP3 and WMA fi les
Supports playback of discs and USB memory devices on which
MP3 or WMA fi les are recorded. The unit’s display can display the
title of the track and the name of the artist of the current track.
Usable characters “Switching the display” (vpage18, 20)
Low standby power consumption
Designed with the environment in mind, the unit consumes just
0.3W while in standby mode.
Cautions on handling
• Before turning the power switch on
Check once again that all connections are correct and that there are
no problems with the connection cables.
• Power is supplied to some of the circuitry even when the unit is
set to the standby mode. When going on vacation or leaving home
for long periods of time, be sure to unplug the power cord from the
power outlet.
• Proper ventilation
If the unit is left in a room full of smoke from cigarettes, etc., for
long periods of time, the surface of the optical pickup may get dirty,
preventing it from receiving signals properly.
• About condensation
If there is a major difference in temperature between the inside of
the unit and its surroundings, condensation may form on parts inside
the unit, causing it to fail to operate properly.
If this happens, let the unit sit for an hour or two with the power
turned off and wait until there is little difference in temperature
before using the unit.
• Cautions on using mobile phones
Using a mobile phone near this unit may result in noise. If that
occurs, move the mobile phone away from this unit when it is in use.
• Moving the unit
Turn off the power and unplug the power cord from the power outlet.
Next, disconnect the cables connected to other system units before
moving the unit.
About this manual
n Operation buttons
The operations described in this manual are based mainly on
remote control operation.
n Symbols
v
This symbol indicates a reference page on which
related information is described.
This symbol indicates a supplementary information
and tips for operations.
NOTE
This symbol indicates points to remember operations
or function limitations.
n Illustrations
Note that the illustrations in these instructions are for explanation
purposes and may differ from the actual unit.
Thank you for purchasing this DENON product. To ensure proper
operation, please read this owner’s manual carefully before using the
product.
After reading the manual, be sure to keep it for future reference.
Accessories
Check that the following parts are supplied with the product.
q e
r t
q
Remote control (RC-1127) .......................................................1
w R03/AAA batteries ...................................................................2
e Power cord (Cord length: Approx. 6.6 ft / 2 m) .......................1
r AM loop antenna .....................................................................1
t FM indoor antenna ..................................................................1
y Owner’s manual ......................................................................1
u Warranty (for North America model only) ................................1
i Service network list .................................................................1
Getting started