25
ENGLISH
13
PLAYING MP3 FILES
2 There are many sites on the Internet from which you can download music files in MP3 format. These files
can be downloaded following the instructions on the site and stored on CD-R/RW discs which can then be
played on the D-107.
The music on commercially available music CDs can be converted into MP3 files on a computer using MP3
encoding programs. When this is done, the data is reduced to approximately 1/10 the original size. This MP3
data can then be stored on a CD-R/RW disc, allowing you to create a single 12 cm CD-R/RW disc containing
about 10 times more music than a normal music CD, that is some 100 tracks or more (*).
* This is an approximately value for MP3 files of tracks about 5 minutes long converted at a standard bit rate
(128 kbps) and stored on a CD-R/RW disc with a capacity of 650 MB.
Recordings you make are for your personal use and should not be used in ways infringing upon the
copyright holder as per copyright laws.
NOTES:
• The D-107 is compatible with “MPEG-1 Audio
Layer-3” and “MPEG-2 Audio Layer-3” standards
(sampling frequencies - 32 kHz, 44.1 kHz and 48
kHz). It is not compatible with “MPEG-2.5 Audio
Layer-3”, MP1 or MP2 standards.
• When writing MP3 files on a CD-R/RW disc, set
the writing program’s format to “ISO9660 level
1” or “ISO9660 level 2”, “Joliet”or “Romeo”.
MP3 files written in other formats may not play
properly. With some writing programs it is not
possible to record in “ISO9660” format. Use an
“ISO9660” format writing program.
• Generally speaking, the higher the MP3 file’s bit
rate, the better the sound quality. With the D-107
it is recommended to use MP3 files written with
a bit rate of 128 kbps or greater.
• The writing program may change the positions of
the folders and files when writing the MP3 files
on the CD-R/RW disc, so the files may not be
played in the expected order.
• Make sure to give MP3 files the extension
“.MP3”. Files with extensions other than “.MP3”
or without extensions cannot be played. (On
Macintosh computers, MP3 files can be played by
adding the extension “.MP3” after the file name
consisting of a maximum of 8 Roman capital
letters and/or numerals when recording them on
CD-R/RW discs.)
• To protect copyrights, no digital signals are output
when playing MP3 files.
• A maximum of 512 folders can be played on the
D-107. Folders over 8 layers down, however,
cannot be played. The maximum number of files
is also 512. If there are 513 files, only the first
512 are played. (Random playback is not possible
if there are 257 or more files. Files other than
those with the extension “.MP3” are not
counted.)
• On the D-107, folder and file names can be
displayed like titles. Roman capital letters and/or
numerals and “__” (underscores) are scrolled.
(However, a maximum of 12 characters can be
displayed in the “Joliet” mode and 32 characters
in the “Romeo” mode.) In addition, folder and file
names using other symbols will not be displayed
properly.
• The D-107E is compatible with ID3-tag (Ver. 1.*).
• It may not be possible to play some CD-R/RW
discs due to dirt, scratches or the disc’s
properties.
• Do not apply seals or tape to the label or signal
side of CDs or CD-R/RW discs. The glue could
get on the disc surface, making the disc get stuck
inside the set.
• The D-107 is multi-session compatible.
Only music CDs can be played if the first session
is a music CD, and only MP3 files can be played if
the first session consists of MP3 files.
• The D-107 is not compatible with packet write
programs.
• The D-107 is not compatible with play lists.
CLEAR
123
546
789
+1 0
10
TONE/SDB
REPEAT
CALL
PROG/
DIRECT
RANDOM
ENTERDISPLAY MENU
SLEEPFOLDERTITLETIME
STOP
/BAND
PLAY/PAUSE
VOLUME
FUNCTIONMUTE
PRESET
+
-
1
2
2
3
The single track repeat mode can also be set by
pressing the REPEAT button during playback.
The current track is played repeatedly.
To cancel the single track repeat mode, press
the REPEAT button repeatedly until the “”
indicator turns off.
1
Press the number buttons or 9,
8 buttons to input the number of
the desired track.
2
PRESET
+
-
123
546
789
+1 0
10
or
In the stop mode, press the
REPEAT button once.
• The “” indicator lights.
1
1
REPEAT
Step 3 can be skipped when a track is
selected using the number buttons.
Press the 1/3 button.
• Playback starts.
• Once the selected track ends,
it is played again from the
beginning.
3
PLAY/PAUSE
Playing a single track repeatedly [Single track repeat]
NOTE:
The single track repeat mode cannot be set
during programmed playback or random playback.
Press the REPEAT button once.
4th track 5th track3rd track
This operation is
repeated.