Filter
Top Products
ENGLISH
34
NOTE:
To prevent hearing loss, do not raise the volume level excessively
when using headphones.
[3] Turning the sound off temporarily (muting)
1
Use this to turn off the audio output
temporarily.
Press the MUTING button.
*
Cancelling MUTING mode.
Press the MUTING button again.
MUTING
SPEAKER
DOLBY / DTS
SURROUND
DIRECT
DSP SIMULATION
5CH STEREO STEREO
INPUT MODE
ANALOG EXT.IN
MUTING
MASTER VOL.
AVR/AVC VIDEO DVD TV
AUDIO
VDP VCR
CD
CDR/MDDECK
1
[2] Listening over headphones
1
Connect the headphones to the
PHONES jack of the front panel.
1
PHONES
2
• The output to the speaker and pre-out
jacks is turned off and no sound is
produced from the speakers.
(Remote control unit)
Press the SPEAKER A or B to turn the
speaker off.
[5] Checking the currently playing program source, etc.
1
On screen display
• Each time an operation is performed,
a description of that operation
appears on the display connected to
the unit’s VIDEO MONITOR OUT
jack. Also, the unit’s operating status
can be checked during playback by
pressing the remote control unit’s ON
SCREEN button.
Such information as the position of
the input selector and the surround
parameter settings is output in
sequence.
RETURN
ON SCREEN
Front panel display
• Descriptions of the unit’s
operations are also displayed
on the front panel display. In
addition, the display can be
switched to check the unit’s
operating status while
playing a source by pressing
the STATUS button.
STATUS
STATUS
DISPLAY
(Main unit) (Remote control unit)
TUNING
BAND
TITLE
MENU/GUIDE
MODE
MEMORY
USE/LEARN T.TONE DVD
SET UP
RETURN
STATUS
DISPLAY
ON SCREEN
SYSTEM
SETUP
SURROUND
PARAMETER
CH SELECT
SELECT
ENTER
1
1
Using the dimmer function
• Use this to change the brightness of the display.
The display brightness changes in four steps
(bright, medium, dim and off) by pressing the
remote control unit’s DIMMER button repeatedly.
*
The brightness changes in 3 steps each time the
button is pressed, and finally the display turns off.
DIMMER
(Main unit)
(Remote control unit)
[4]
Combining the currently playing sound with the desired image
1
Simulcast playback
Use this switch to monitor a video
source other than the audio source.
Press the VIDEO SELECT button
repeatedly until the desired source
appears on the display.
*
Cancelling simulcast playback.
VIDEO SELECT
• Select “SOURCE” using the video select button.
• Switch the program source to the component connected to
the video input.
(Main unit)
(Main unit)