Filter
Top Products
43
Advanced Setup Advanced Setup
ENGLISH
• The audio delay setting does not apply when playing in the EXT.
IN mode or in the analog input direct mode or stereo mode.
• By default, this menu is not displayed when no digital signals
are being input.
The surround mode used last for the three types of input signals
shown below is stored in the memory, and the signal is
automatically played with that surround mode the next time it is
input.
Note that the surround mode setting is also stored separately for
the different input sources.
q Analog and PCM 2-channel signals (STEREO)
w 2-channel signals in the Dolby Digital, DTS or another multi-
channel format (DOLBY PLIIx Cinema)
e Multi-channel signals in the Dolby Digital, DTS or another multi-
channel format (DOLBY/DTS SURROUND)
Default settings are indicated in ( ).
Setting the Auto Surround Mode
Press the CURSOR
FF
or
GG
button to select the Auto
Surround mode, then press the ENTER or CURSOR
HH
button to switch the Ext. In Subwoofer Level
setting.
*Auto Surr. ON
ON OFF
• When watching a DVD or other video source, the picture on the
monitor may seem delayed with respect to the sound. In this
case, adjust the audio delay to delay the sound and synchronize
it with the picture.
• The audio delay setting is stored separately for each input
source.
Setting the Audio Delay
Press the CURSOR
FF
or
GG
button to set the delay
time, then press the ENTER or CURSOR
HH
button to
switch the Auto Surround Mode setting.
With a movie source, for example, adjust so that the
movement of the actors’ lips is synchronized with the sound.
*A.Delay 0ms
0ms 100ms 200ms
Set the method of playback of the analog input signal connected
to the EXT. IN terminal.
Setting the Ext. In Subwoofer Level
Press the CURSOR
FF
or
GG
button to select the ext. in
subwoofer channel level playback, then press the
ENTER or CURSOR
HH
button to switch the Power
Amp Assignment setting.
*Ext.In SW+15dB
+0dB +5dB +10dB +15dB
Make this setting to switch the power amplifier for the surround
back channel to ZONE2.
Setting the Power Amp Assignment
Press the CURSOR
FF
or
GG
button to select “S. Back”
or “ZONE2”, then press the ENTER or CURSOR
HH
button if you want to start the settings over from the
beginning.
*P.Amp S.Back
S.Back ZONE2
MAIN ZONE
Surround back 7.1ch system
ZONE2 5.1ch system
Power Amp
Assign.
ZONE2
–
2ch system
SPEAKER OUT
ENGLISH