Filter
Top Products
19
Before setting up the system
3
4
Press the SYSTEM SETUP button to enter the setting.
Turn on the power.
Press the Power ON/STANDBY switch (button).
5
Press the ENTER or (down) button to switch to the speaker configuration set up.
*SYSTEM SET UP
NOTE:
Press the SYSTEM SETUP button again to finish system set up. System set up can be finished at any time. The changes to the settings
made up to that point are entered.
NOTE: Please make sure the “AUDIO” position of the slide switch on the remote control unit.
(Main unit) (Remote control unit)
Setting the speaker configuration
1
Use the (left) and (right) buttons to select your front speaker type.
1 FRONT LARGE
LARGE
SMALL
(left) button (right) button
Press the ENTER or (down) button to switch to the center speaker setting.
2
Use the (left) and (right) buttons to select your center speaker type.
2 CENTER SMALL
LARGE
SMALL
NONE
(left) button (right) button
Press the ENTER or (down) button to switch to the surround speaker setting.
NOTE:
• When “Small” has been selected for the front speakers, “Large” cannot be selected for the center speaker.
(Initial)
(Initial)
2
Press the Power switch (button) .
(Main unit)
• ¢ ON
The power turns on and indicator is light.
Set the power switch to this position to turn the power on and off from the included remote control unit.
• £ OFF
The power turns off and indicator is off.
In this position, the power cannot be turned on and off from the remote control unit.
ENGLISH
1
Refer to “CONNECTIONS” (pages 10 to 16) and check that all connections are correct.