Denon AVR-1705 Stereo System User Manual


 
10
8
CONNECTIONS
Do not plug in the power cord until all connections have been
completed.
Be sure to connect the left and right channels properly (left with
left, right with right).
Insert the plugs securely. Incomplete connections will result in
the generation of noise.
Use the AC OUTLETS for audio equipment only. Do not use
them for hair driers, etc.
Note that binding pin plug cords together with power cords or
placing them near a power transformer will result in generating
hum or other noise.
Noise or humming may be generated if a connected audio
equipment is used independently without turning the power of
this unit on. If this happens, turn on the power of the this unit.
Connecting the audio components
LINE OUT
SURROUND
SUB WOOFER
CENTER
FRONT
LINE OUT
LINE OUT
LINE IN
R
OUTPUTINPUT
LRL
R
OUTPUT
L
R
L
R
L
R
L
L
R
L
R
R
L
R
L
L
R
DIGITAL AUDIODIGITAL AUDIO
INPUTOUTPUT
OPTICAL
B
Connecting a CD player
Connect the CD player’s analog output jacks
(ANALOG OUTPUT) to this unit’s CD jacks using
pin plug cords.
Decoders with 6-channel
analog outputs, etc.
DIGITAL jacks
Use these for connections to audio equipment with digital output.
Refer to page 26 for instructions on setting this terminal.
Connecting the AC OUTLETS
AC OUTLETS
• SWITCHED
(total capacity – 120 W (1 A.))
The power to these outlets is turned on and off in conjunction with the POWER switch
on the main unit, and when the power is switched between on and standby from the
remote control unit.
No power is supplied from these outlets when this unit’s power is at standby. Never
connect equipment whose total capacity is above 120 W (1 A.)
NOTE:
Only use the AC OUTLETS for audio equipment. Never use them for hair driers, TVs or
other electrical appliances.
AC CORD
AC 120V, 60Hz
Connect the internal amplifier’s subwoofer to the subwoofer
terminal. (Refer to page 15.)
Connecting a tape deck
Connections for recording:
Connect the tape deck’s recording input jacks (LINE IN or REC)
to this unit’s tape recording (OUT) jacks using pin plug cords.
Connections for playback:
Connect the tape deck’s playback output jacks (LINE OUT or
PB) to this unit’s tape playback (IN) jacks using pin plug cords.
CD player
Tape deck or CD recorder
Use 75 /ohms cable pin cords (sold separately) for coaxial
connections.
Use optical cables (sold separately) for optical connections.
Subwoofer jack
CD recorder, MD recorder or other component
equipped with digital output jacks.
ENGLISH