ENGLISH
Getting Started
• The DCD-1500AE can be controlled from a distance using the included remote control unit (RC-1020).
q Remove the remote control unit’s rear cover.
w Place 2 R03/AAA batteries in the battery compartment in
the direction indicated by the marks.
e Close the rear cover.
Cautions on Batteries:
• Use R03/AAA batteries in this remote control unit.
• Replace the batteries with new ones approximately once
a year, though this depends on the frequency with which
the remote control unit is used.
• If the remote control unit does not operate from close to
the main unit, replace the batteries with new ones, even
if less than a year has passed.
• The included batteries are only for verifying operation.
Replace it with a new battery as soon as possible.
• When inserting the batteries, be careful to do so in the
proper direction, following the < and > marks in the
remote control unit’s battery compartment.
•To prevent damage or battery fluid leakage:
•Do not use a new battery with an old one.
• Do not use two different types of batteries.
• Do not short-circuit, disassemble, heat or dispose of
batteries in flames.
• Remove the batteries when not planning to use the
remote control unit for a long period of time.
• If the batteries should leak, carefully wipe off the fluid
from the inside of the battery compartment, then insert
new batteries.
Inserting the batteries
Operating range of the remote control unit
• When operating the remote control unit, point it at the
remote control sensor as shown in the figure.
• The remote control unit can be used from a direct distance
of approximately 8 meters. This distance will be shorter,
however, if there are obstacles in the way or if the remote
control unit is not pointed directly at the remote control
sensor.
• The remote control unit can be operated at a horizontal angle
of up to 30° with respect to the remote control sensor.
30°
30°
Approx. 8 meters
NOTE:
• It may be difficult to operate the remote control unit if the
remote control sensor is exposed to direct sunlight or
strong artificial light.
• Do not press the buttons on the main unit and on the
remote control unit at the same time. Doing so will result
in malfunction.
3
ENGLISH