Filter
Top Products
ENGLISH
Page
Troubleshooting
1. Are all the connections correct?
2. Are you following the instructions in the operating instructions?
3. Are the amplifier and speakers operating properly?
If the DCD-1500AE does not seem to be functioning properly, check the table below. If this does not solve the problem, the DCD-
1500AE may be defective. Turn off the power, unplug the power cord from the power outlet, and contact your store of purchase
or nearest DENON sales office.
Symptom Check
Disc holder does not open or close.
• Is the power on?
When a disc is loaded, “NO DISC” is displayed.
• Is the disc loaded properly?
When the 1 button is pressed, playback does not
start.
• Is the disc dirty or scratched?
There is no sound or it is distorted.
• Is the output cord properly connected to the amplifier?
•
Have the amplifier controls been set correctly?
No data is output from the digital output terminal
(OPTICAL/COAXIAL).
•
With Super Audio CDs, no digital signals are output.
•
Is the PURE DIRECT mode on?
A specific section of the disc will not play.
•
Is the disc dirty or scratched?
Programmed playback does not work.
•
Has programming been properly done?
CD-R and CD-RW discs cannot be played.
•
For CD-R/-RW discs, has the disc been finalized?
Incorrect operation when buttons on the remote
control are pressed.
•
Is the remote control unit being operated too far from the CD player?
•
Are there obstacles blocking the ray?
•
Is the remote control sensor exposed to strong light?
•
Are the batteries exhausted?
Check again before assuming the player is malfunctioning
7
2 , 7
2
6
–
6
4
2
9
2
3
–
–
–
11
ENGLISH
When a disc is loaded, “00m 00s” is displayed. • Are you attempting to play a disc other than a CD or Super Audio CD? 2
Timer-controlled playback
1
Turn on the power of all system components.
4
Check the time on the timer and then set the
desired turn-on time.
2
Set the input selector on the amplifier to
correspond to the inputs the CD player is
connected to.
3
Make sure a disc has been loaded in the disc
holder.
5
6
Turn the audio timer ON.
When the preset turn-on time is reached,
power is turned on in the system components
and CD playback starts from the first track.
Power is turned off automatically in all components
connected to the timer.