Filter
Top Products
Getting Started Connections Setup Remote Control Multi-Zone Information Troubleshooting
ENGLISH
Plug the headphones into <PHONES>.
The sound from the speakers and pre-out connectors is automatically
cut.
NOTE
Be careful not to set the volume too high when using headphones.
Listening with Headphones
Press <SPEAKER>.
Switching the front speakers
Video Select Function
Switch video input source while listening to audio signal.
Press VIDEO SELECT until the desired picture appears.
b To cancel, press VIDEO SELECT to select “SOURCE”.
Playing Video and Audio Equipment
1
Prepare the equipment.
q Load the DVD, CD or other software in the player.
(vSee the operating instructions of the respective devices.)
w To play a video device, switch the monitor input.
(vSee the monitor’s operating instructions.)
2
Use SOURCE SELECT to select the input source.
3
Set [MODE SELECTOR 1] to “AUDIO” or “VIDEO”.
(vpage 43 “Remote Control Unit Operations”)
4
Set [MODE SELECTOR 2] to the component you want
to operate.
5
Start playback.
(vSee the operating instructions of the respective devices.)
Basic Operation
Press [MUTING].
To cancel, press [MUTING] again. Muting can also be canceled by
adjusting the master volume.
Turning Off the Sound Temporarily (Muting)
1
Either turn <SOURCE SELECT> or press [TUNER] to
select “TUNER”.
2
Set [MODE SELECTOR 1] to “AUDIO”.
(vpage 43 “Remote Control Unit Operations”)
3
Press BAND to select “FM” or “AM”.
4
Tune in the desired broadcast station.
q To tune in automatically (Auto Tuning)
Press [MODE] to light the “AUTO” indicator on the display, then use
TUNING to select the station you want to hear.
w To tune in manually (Manual Tuning)
Press [MODE] to turn off the display’s “AUTO” indicator, then use
TUNING to select the station you want to hear.
Listening to FM/AM Broadcasts
• It is also possible to switch to “FM” or “AM” in step 1 by pressing
[TUNER].
• If the desired station cannot be tuned in with auto tuning, tune it in
manually.
• When tuning in stations manually, press and hold TUNING to change
frequencies continuously.
Basic Operation
Press STATUS.
The current program source and various settings are indicated on
the display.
For details, refer to “Information” (vpage 34).
Press DIMMER.
Bright Dim
DarkOFF
Playback
Checking the currently playing program source, etc.
Switching the brightness of the display (Dimmer)