Filter
Top Products
System Setup System Setup
ENGLISH
17
ENGLISH
Perform this setting if you wish to make the settings for your speaker
systems manually.
Speaker Setup
Setting the Speaker Configuration
Automatically set the output component and properties for the
various channels according to the combination of speakers to be
actually used for surround playback.
Press
FF GG
to select “1. Sp”, then press ENTER.
Press
DD HH
to select the speaker, then press
FF GG
to set.
Large:
Select this when using large speakers with ample low frequency
reproduction capabilities.
Small:
Select this when using small speakers without ample low
frequency reproduction capabilities.
Yes / No:
Select “Yes” when a subwoofer is connected, “No” when no
subwoofer is connected.
None:
Select this when no speaker is connected.
1
2
A subwoofer with sufficient low frequency playback capability
can better handle deep bass than most main and surround
speakers, and the system’s overall performance will be greatly
enhanced when “Small” is set for the main (front) and surround
speakers.
When “Front” is set to “Small”, “Subwoofer” is automatically set
to “Yes”, and when “Subwoofer” is set to “No”, “Front” is
automatically set to “Large”.
• Select “Large” or “Small” not according to the actual size of the
speaker but according to the speaker’s capacity for playing low
frequency (bass sound below the frequency set for the Crossover
Frequency) signals. If you do not know, try comparing the sound at
both settings (setting the volume to a level low enough so as not to
damage the speakers) to determine the proper setting.
S p e a k e r S e t u p
1 F r o n t L a r g e
2
4 S u b w o o f e r Y e s
1
5 S W M o d e N o r m
3
Press ENTER or
HH
to enter the setting and switch to
the Subwoofer Mode Setup setting.
3
Setting the Subwoofer Mode Setup
Select the method of playback of the subwoofer for playing the low
bass signals.
LFE (Normal):
For any channel(s) that are set to “Large”, low frequencies in that
channel’s corresponding source are directed to that loudspeaker
only. The low frequencies played from the subwoofer are only the
LFE signals and the low frequencies of channels set to “Small”.
LFE+Main:
Low frequencies from speaker channels that have been set to
“Large” are reproduced from those speakers as well as from the
subwoofer(s).
• The subwoofer mode setting is only valid when and “Yes” is set for
the subwoofer in the “Setting the Speaker Configuration”.
• Select the “LFE+Main” mode if you want low frequency signals to
always be played from the subwoofer channel.
• Select the mode achieving a voluminous bass sound when playing
music or movie sources.
Press ENTER or
HH
to enter the setting and switch to
the Distance setting.
2
Press
FF GG
to set.
1
5 S W M o d e +Main
1
6 F L 1 2 f t
2