Denon AVR-487 Stereo Receiver User Manual


 
Easy Operation Easy Operation
ENGLISH
ENGLISH
9
Before operating
Press
<
ON/STANDBY
>
or [ON/SOURCE].
The power indicator blinks green and the power turns on.
Press
<
POWER
>
.
£ OFF:
The power turns off and the indicator is off.
¢ ON:
The power indicator lights red.
Turn on your subwoofer.
Set the volume to halfway and set the crossover frequency to
the maximum or Low pass filter off if your subwoofer can adjust
the output volume and the crossover frequency.
Some subwoofers have a standby mode. Be sure to turn this
function off before performing the Auto Setup procedure.
Turn on your monitor.
1
2
3
4
Set [MODE SELECTOR 1] to “AUDIO”.
6
Press
<
SPEAKER
>
to select the front speaker (Front
A, Front B or Front A+B).
5
Playing the input source
Use INPUT SELECTOR to select the input source you
want to play.
Start playback on the selected component.
For operating instructions, refer to the component’s manual.
1
3
Press INPUT MODE.
AUTO
EXT. IN ANALOG
PCM DTS
2
Press
<
ANALOG
>
to select “ANALOG”,
<
EXT. IN
>
to select “EXT.
IN”.
<POWER> <ANALOG>
INPUT MODE
INPUT SELECTOR
VOLUME
<SPEAKER>
<EXT.IN>
<ON/STANDBY>
About the button names in this explanation
<>: Buttons on the main unit
[]: Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
Use VOLUME to adjust the volume.
The volume level is displayed on the master volume level
display.
4
[MODE SELECTOR 1]
[ON/SOURCE]
VOLUME
INPUT SELECTOR
INPUT MODE
INPUT SELECTOR