Filter
Top Products
Advanced Operation Advanced Operation
42
ENGLISH
ENGLISH
¢Last function memory
The various settings set when the AVR-1907’s power is switched to
standby are stored in the memory. When the power is turned back on,
the settings made when the power was switched to standby are
recalled.
About the memory functions
¢Backup memory
The various settings are stored in the memory for about 1 week, even
when the power is turned off or the power cord is unplugged.
Initialization of the microprocessor (Reset)
Use the procedure described below to reset the microprocessor if the
display is abnormal or if the buttons on the main unit or the remote
control unit do not operate.
Switch off the unit using
<
POWER
>
.
1
Check that the entire display is blinking with an interval
of about 1 second, and release your fingers from the 2
buttons.
• The microprocessor will be initialized.
3
Hold the following
<
SPEAKER
>
(A and B) and press
<
POWER
>
.
2
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the settings are reset to the
default values.
Recording (audio and/or video)
Press
<
ZONE2/REC SELECT
>
until “RECOUT” appears
on the display.
Use
<
FUNCTION
>
to select the source to be recorded
(audio and/or video).
• The “ ” indicator and the indicator for the selected
source light.
Record (the audio or video signals).
For operations, see the operating instructions of the device from
which you are recording (audio or video signals).
•To cancel, press
<
ZONE2/REC SELECT
>
and set the function to “ZONE2”.
1
2
3
NOTE:
• When the REC OUT mode is selected, [ZONE2] and [FUNCTION]
(ZONE2) cannot be operated.
• Digital signals are not output from the analog REC OUT terminal.
RECOUT
ZONE2