Filter
Top Products
support.dell.com Rack Installation Guide 1-21
Installing the Inner Rails on the System Chassis
To install the inner rails to the sides of the system, perform the following steps.
CAUTION: The system may weigh up to 10 kilograms (23 pounds) when
fully loaded. To prevent personal injury, do not attempt to move the system
by yourself.
1. Place the system on its side (see Figure 1-18) on a piece of foam or cardboard (to
prevent damage to the system) while you install the inner rails to the sides of the
system.
Figure 1-18. Installing the Inner Rails
2. Secure each inner rail to the side of the chassis with three 10-24 x 0.375-inch pan-
head Phillips screws (see Figure 1-18).
Installing the System in the Four-Post Rack
WARNING: If you are installing more than one system, install the first sys-
tem in the lowest available position in the rack.
WARNING: Never pull more than one component out of the rack at a time.
1. Pull the two interior slide assemblies out of the rack until they lock in the
extended position.
CAUTION: Because of the size and weight of the system, never attempt to
install the system in the slide assemblies by yourself.
2. Lift the system into position in front of the extended slides.
Grasp the system with one hand on the right side of the system and the other
hand on the left side of the system.
inner rail (2)
10-24 x 0.375-inch pan-
head Phillips screws (6)
2D786bk0.book Page 21 Thursday, January 18, 2001 8:44 PM