6 STARLINE
SG2-DRT-3X Installation Sheet
TP XMTR A and Pad XMTR A are not used, therefore, it is not necessary to pad the
XMTR A location as no signal is present.
8 Close the housing and use a torque wrench to progressively tighten the housing bolts to a
final torque of 12 ft-lbs. in the sequence stamped on the housing lid.
Figure 6 illustrates a properly installed and cabled SG2-DRT-3X:
Figure 6
SG2-DRT-3X installed in SG2440