Filter
Top Products
INVISIBLE LASER RADIATION
PEAK POWER 5.0mW
WAVELENGTH 1300nm
CLASS IIIb LASER PRODUCT
CHAPTER 1 SUBCHAPTER J
THIS PRODUCT COMPLIES WITH 21CFR
AVOID DIRECT EXPOSURE TO BEAM
DANGER
This is a class 1 product that contains a class IIIb laser and is intended for operation in a closed environment
with fiber attached. Do not look into the optical connector of the transmitter with power applied. Laser output is
invisible, and eye damage can result. Do not defeat safety features that prevent looking into optical connector.
This product contains a class IIIb laser and is intended for operation in a closed environment with fiber
attached. Do not look into the optical connector of the transmitter with power applied. Laser output is invisible,
and eye damage can result. Do not defeat safety features that prevent looking into optical connector.
This symbol indicates that dangerous voltage levels are present within the equipment. These voltages are not
insulated and may be of sufficient strength to cause serious bodily injury when touched. The symbol may also
appear on schematics.
The exclamation point, within an equilateral triangle, is intended to alert the user to the presence of important
installation, servicing, and operating instructions in the documents accompanying the equipment.
For continued protection against fire, replace all fuses only with fuses having the same electrical ratings
marked at the location of the fuse.
Electrostatic discharge (ESD) can damage the MPS unit and circuit card assemblies. Wear an antistatic wrist
strap attached to a chassis ground to prevent ESD damage.
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one of the following measures:
! Re-orient or relocate the receiving antenna
! Increase the separation between the equipment and receiver
! Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
! Consult the dealer or an experienced radio/TV technician for help.
Changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
Canadian Compliance
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe B est conforme ả la norme NMB-003 du Canada.