Filter
Top Products
Operation Manual
Micro-Tech Series Power Amplifiers
page 20
8 Specifications
Minimum Guaranteed Power MT-600 MT-1200 MT-2400
120 VAC, 60 Hz Units, Stereo mode, per channel, both channels driven
1 kHz with 0,1% THD
Stereo, 2 ohms (per ch.)
Stereo, 4 ohms (per ch.)
Stereo, 8 ohms (per ch.)
400 W
325 W
220 W
675 W
480 W
310 W
1,050 W
800 W
520 W
120 VAC, 60 Hz Units, Bridge mono mode
1 kHz with 0.1% THD
Bridge mono, 4 ohms
Bridge mono, 8 ohms
Bridge mono, 16 ohms
750 W
655 W
450 W
1,300
970 W
620 W
2,070 W
1,585 W
1,035 W
120 VAC, 60 Hz Units, Parallel mono mode
1 kHz with 0.1% THD
Parallel mono, 1 ohm
Parallel mono, 2 ohms
Parallel mono, 4 ohms
700 W
665 W
450 W
1,300 W
965 W
620 W
2,080 W
1, 605 W
1, 035 W
Performance MT-600 MT-1200 MT-2400
Frequency Response (at 1 watt, 20Hz - 20 kHz) ± 0.1 dB ± 0.1 dB ± 0.1 dB
Phase Response (at 1 watt, 20Hz - 20 kHz) ±10° ±10° ±10°
Signal to Noise Ratio below full bandwidth power
20 Hz to 20 kHz
A-weighted
>100 dB
>105 dB
>100 dB
>105 dB
>100 dB
>105 dB
Total Harmonic Distortion (THD) at rated power, from 20 Hz to 20 kHz 0.1% 0.1% 0.1%
Intermodulation Distortion (IMD) 60 Hz and 7 kHz at 4:1,
from 163 milliwatts to full bandwidth power < 0.05% < 0.05% < 0.05%
Damping Factor: 10 Hz to 400 Hz >1000 >1000 >1000
Crosstalk (below rated power, 20 Hz to 20 kHz) > 60 dB > 60 dB > 60 dB
Common Mode Rejection (CMR) (20 Hz to 1 kHz) > 70 dB > 70 dB >70 dB
DC Output Offset (Shorted input) ±10 mV ±10 mV ±10 mV
Input Impedance (nominally balanced, nominally unbalanced) 20 k ohms, 10 k ohms 20 k ohms, 10 k ohms 20 k ohms, 10 k ohms
Load Impedance (Note: Safe with all types of loads)
Stereo
Bridge Mono
Parallel Mono
2-16 ohms
4 -16 ohms
1-4 ohms
2-16 ohms
4 -16 ohms
1-4 ohms
2-16 ohms
4 -16 ohms
1-4 ohms