Crosley Radio cr-224 Radio User Manual


 
Radio Operation
XM Radio
XM $12.95 monthly service subscription sold seperately. XM Passport or
Connect and Play system required to receive XM service (sold seperately).
Installation costs and other fees and taxes, including a one-time activation
fee may apply. Subscription fee is consumer only.
All fees and programming subject to change. Channels with frequent explicit language are indicated with an XL.
Channel blocking is available for XM radio receivers by calling 1-800-XMRADIO. Subscriptions subject to Customer
Agreement available at xmradio.com. XM service only available in the 48 contiguous United States. [XM Ready,
XMDirect*] are trademarks of XM Satellite Radio Inc. ©2006 XM Satellite Radio Inc. All rights reserved.
XM Setup
By using the XM Setup, you can customize how you search for programming.
Search Method Allows you to search by Category or Channel.
Direct Tune – With Direct Tune on, the Explorer I will automamatically switch to a
selected station. With Direct Tune off, find the desired station, and press enter to select.
Diagnostic – Monitor signal and satellite strength.
Listening to XM Radio
1. With the power turned on, press the Mode Button to highlight XM and press
Tuning Knob or Enter on remote to select.
2. Rotate the Tuning Knob to select a channel and press to enter.
3. If using Category Mode, select a category and rotate the Volume Knob to
select a channel. Press the Tuning Knob to enter the selected channel.
4. Adjust volume to desired listening level.
AM/FM Radio
1. With the power turned on, press the Mode Button to highlight either AM or FM.
2. Rotate the Tuning Knob to select a desired station and press to enter.
3. Adjust volume to desired listening level.
Station Presets
Programming Stations into Memory.
You can program up to 20 AM, 20 FM and 20 XM stations into the memory.
1. Select the mode in which you wish to program the presets (AM, FM, XM).
2. Select a station or channel you wish to program.
3. Using the remote control, press the memory Button repeatedly until the
desired preset location is reached. Ex: 4/20.
4. Press the Enter key on the remote to store the desired station/channel.
5. Repeat steps 1-4 to store other presets.
11
cr224Manual.qxd 9/22/06 11:35 AM Page 13