Filter
Top Products
Wyndsor
PHONO PRE-AMPLIFIER
TECHNICAL SPECIFICATION
Gain 5 steps in dBs 40, 45, 53, 61, 70
Distortion < 0.005 @ 1kHz
Frequency Response 0.5 Hz – 100 kHz (+/- 0.5dB)
IEC roll-off (7950us) -3dB @ 20 Hz -6dB @ 10Hz
Noise in dBs in 5 gain settings -92, -81, -79, -72, -62.5
Separation < 93dB
DC Offset < +/- 10mV
Input Capacitance 100pF, 440pF, 1.1nF, 1.4nF
Input Resistance 91R, 100R, 1k, 33k, 47k
Wyndsor Power Supply Unit 2 toroidal mains transformers and low noise regulators
Switchable Mains Voltage Selector 115/230V AC External
Specification subject to change without notice
WARRANTY
If within two years of the purchase date your Wyndsor phono pre-amplifier product proves to be defective for any
reason other than accident, misuse, neglect, unauthorised modification or fair wear and tear, Creek Audio Ltd
will, at its discretion, replace the faulty parts without charge for labour or return carriage within the U.K. This
warranty is valid only within the U.K. and given in addition to statutory rights. Service enquiries outside the U.K.
should be addressed first to the supplying dealer and or Creek distributor/importer. Warranties granted in these
countries are entirely at the discretion of the distributor.
Creek Audio Limited
12 Avebury Ct, Mark Road, Hemel Hempstead HP2 7TA England
Telephone: +44 (0) 1442 260146 Fax: +44 (0) 870 622 0846
E-mail: info@creekaudio.com Web: www.creekaudio.com
E&OE
SW (SOFTWARE) VERSION
This displays the current version of the software in the device. Updates, as they become available, can be installed
via a replaceable electronic chip inside the case. Press any button to go back to the main menu.
A DIN plug is provided to enable the correct cable to be produced for balanced input connection. The wiring
configuration is noted on the rear panel. Please consult your dealer if in any doubt. Additional information can be
accessed from the FAQ section of the Creek Audio website.