Filter
Top Products
Wyndsor
PHONO PRE-AMPLIFIER
OPERATING INSTRUCTIONS
GLOSSARY
PARAMETERS – Refers to cartridge type, load resistance and capacitance, arm wiring and equalisation.
PROFILE – A set of parameters stored in memory with a name.
MAIN SCREEN
At start up, a CREEK AUDIO message is displayed for 2 seconds. Display brightness is restored to its last used
value. Note: if the last used parameters are stored without a name, only the parameters will be shown. If the last
used parameters are assigned a name (referred to as a profile), the name is displayed. However when the
encoder is rotated, the screen is changed to display the parameters. While in the main screen, rotate the
encoder to the right to see the active parameters. Rotate the encoder to the left to see name of current profile if
available.
MAIN MENU
Hold the encoder button for at least 1 second to access the main menu. Rotate the encoder to choose from 6
menu items:
1. SELECT PROFILE
2. DISPLAY LEVEL
3. EDIT PARAMS
4. EDIT PROFILE
5. DELETE ALL
6. SW VERSION
Press the BACK button to return to the main screen at any time.
SELECT PROFILE
Rotate the encoder to navigate through the list of available profiles. When a profile is shown, press the encoder
button briefly to see the parameters of that profile. Press it again to go back to the list of available profiles.
Hold the encoder button for at least 1 second to select a profile. SELECTING message will be displayed while the
relays switch to the new settings. Once changes are complete, the SELECTION COMPLETE message will be
displayed. Phono will automatically return to the main screen, showing the name of the newly selected profile.
DISPLAY LEVEL
Choose between 4 brightness levels by rotating the encoder button and press the encoder button briefly to
confirm. Display will return to the main screen.
Note that if you select OFF for display brightness, the screen shows the main menu and only goes blank after
you exit the main menu by pressing the BACK button. To see the screen again, hold the encoder button for 1
second to go into the main menu. Display will come on at minimum brightness.
Note that the mute button operates as usual when the display is switched off.
Page 2