Filter
Top Products
CONTROLS, INDICATORS, AND TERMINALS
FRONT PANEL
Figure 1: Front Panel Terminals and Controls
1. FILTER MODE SELECT SWITCH (MODE)
"HPF": Slide switch to this position if the amplifier is used as a mid/tweeter amplifier.
"OFF": Slide switch to this position if the amplifier is used as a full-range amplifier.
"LPF": Slide switch to this position if the amplifier is used as a subwoofer amplifier.
2. HIGH-PASS / LOW-PASS FREQUENCY SELECTOR KNOB (FREQ)
Adjust high/low-pass crossover frequency between 30 to 300Hz.
3. BASS BOOST CONTROL (BOOST)
Select a boost level between 0 dB and +18 dB to enhance the bass performance of your
sound system.
4. INPUT SENSITIVITY LEVEL CONTROL (SENS)
The input sensitivity level can be varied from 5.0 volts to 100 mV depending on the output
voltage of the source unit (refer to sub-section titled INPUT SENSITIVITY ADJUSTMENT).
5. HIGH IMPEDANCE INPUT (RCA)
To be connected to RCA pre-amp outputs from a source unit (i.e., radio, tape deck or CD play-
er).
6. LOW IMPEDANCE INPUT (SPKR LEVEL)
To be connected to speaker outputs from a source unit (i.e. radio, tape deck or CD player)
when RCA outputs are not available.
7. LINE LEVEL OUTPUT
This output can be used to connect to another amplifier for system expansion.
Note: This line level output is full range.
8. REMOTE SUBWOOFER LEVEL INPUT
To be connected to the optional RS remote subwoofer volume control.
REAR PANEL
Figure 2: Rear Panel Terminals and Indicators
9. POWER AND PROTECT INDICATOR (PWR/PRT)
Green light indicates that the amplifier is "ON".
Red light indicates either a high current, short circuit or DC offset is detected at the speaker
outputs. The amplifier will revert to normal operation once the problem is rectified.
This indicator also lights up at a high operating temperature. Under this condition, the
amplifier will automatically shut down. As soon as the temperature falls to a safe level, the
amplifier will automatically resume operation.
10. POWER INPUT TERMINAL (B+)
To be connected to the positive terminal of the vehicle’s battery or other constant +12 V
source.
11. GROUND INPUT TERMINAL (GND)
To be wired to the vehicle’s chassis for ground.
12. REMOTE TURN-ON INPUT TERMINAL (REM)
To be connected to the remote control wire or power antenna lead of the source unit for
remote ON/OFF.
13. FUSE RECEPTACLE
14. LEFT/RIGHT SPEAKER OUTPUT TERMINAL
For connection to the speaker system.
4
5
www.coustic.com
SPKR LEVEL
INPUT OUTPUT
R
L
SENS
MIN MAX
MODE
HPF OFF LPF
FREQ
30 300
60 180
0 +18
BOOST
REMOTE
+ L - + R -
FUSE
PWR / PRT
BRIDGE
GRD REM B+
14
912 1011 13