Filter
Top Products
Basic Operations
English
15
DXZ775USB
●
Adjusting the bass
2-1. Select “
BASS
”.
3-1. Press the [ ] button.
3-2. Push the [
P.CH
] button upward or
downward to adjust the gain from –6 to +6
(The factory default setting is “
0
”).
3-3. Press the [ ] button to return to the
previous mode.
●
Adjusting the treble
2-1. Select “
TREBLE
”.
3-1. Press the [ ] button.
3-2. Push the [
P.CH
] button upward or
downward to adjust the gain from –6 to +6
(The factory default setting is “
0
”).
3-3. Press the [ ] button to return to the
previous mode.
●
Adjusting the sound restorer
The sound restorer enriches the playback of all
types of music files that have undergone any
level of data compression.
2-1. Select “
S RESTORER
”.
3-1. Push the [
P.CH
] button upward or
downward to adjust.
Each time you push the [
P.CH
] button, the
sound restorer changes in the following
order:
“
OFF
”
↔
“
1
”
↔
“
2
”
↔
“
3
”
∗
The factory default setting is “
OFF
”.\
Set this adjustment in accordance with the
music source used
OFF:
For music sources compressed at
high bit rate
1:
For music sources compressed for high
quality at low bit rate
2:
For music sources compressed for
standard quality at low bit rate
3:
For music sources compressed for low
quality at low bit rate
●
Adjusting the balance
2-1. Select “
BALANCE
”.
3-1. Push the [
P.CH
] button upward to
emphasize the sound from the right
speaker, push the button downward to
emphasize the sound from the left speaker.
∗
The factory default setting is “
0
”.
(Adjustment range: L12 to R12)
●
Adjusting the fader
“
FADER
” can be adjusted only when the
speaker system is set to “
2WAY
” or “
NORMAL
”.
2-1. Select “
FADER
”.
3-1. Push the [
P.CH
] button upward to
emphasize the sound from the front
speaker, push the button downward to
emphasize the sound from the rear
speaker.
∗
The factory default setting is “
0
”.
(Adjustment range: R12 to F12)
●
Setting high pass filter
“HPF” can be adjusted only when the speaker
system is set to “NORMAL”.
2-1. Select “HPF”.
3-1. Push the [P.CH] button upward or
downward to select the setting. Each time
you push the [P.CH] button, the setting
changes in the following order:
“THRGH” ↔ “50Hz” ↔ “80Hz” ↔ “125Hz”
∗ The factory default setting is “THRGH”
(through).
● Setting low pass filter
“S-W LPF” can be adjusted only when the
speaker system is set to “NORMAL” .
∗ If subwoofer function is set to “ST” or “MONO”,
“S-W LPF” can be selected.
2-1. Select “S-W LPF”.
3-1. Push the [P.CH] button upward or
downward to select the setting.
Each time you push the [P.CH] button, the
setting changes in the following order:
“THRGH” ↔ “50Hz” ↔ “80Hz” ↔ “125Hz”
∗ The factory default setting is “THRGH”
(through).
DXZ775USB_EN.book 15 ページ ２００６年１２月２５日 月曜日 午前１１時３７分