Filter
Top Products
Getting Ready
E-6
Ceiling Installation
The Projector System can be hung from a ceiling. The Projector System can be ceiling mounted in an
inverse (upside down) configuration or a vertical configuration.
Important!
Important!
Important!
z To protect against sudden accidental dropping of the Projector System from a ceiling mount
configuration, be sure to secure the cabinet to ceiling fixtures with wires or some other
adequate means.
z When ceiling mounting in a vertical configuration, make sure there is enough work space to
allow access to the fixing screws (two locations marked <A> in the illustration) on the ceiling
side of the cabinet. These screws will need to be loosened and tightened during later
adjustment work.
Contact your original retailer for full details about ceiling mounting.
Important!
Important!
Important!
z When hanging the Projector System from a ceiling, make sure that it is at least one meter away
from fire detectors, fire alarms, and other fire protection devices. Locating the Projector System
too close to a fire protection device creates the risk of mis-operation of the device due to warm
air exhausted from the Projector System. Also, avoid locating the Projector System close to
fluorescent lights or other strong light sources. Bright light can shorten the operating range of
the remote controller or even make remote control impossible. When selecting a location for
the Projector System, be sure to test for proper operation of the remote controller.
z The vertical and horizontal orientation of the projected image is reversed from the normal
configuration when projecting from a Projector System hung from the ceiling. You need to
change the setup of the Projector System in order to correct for this. For more information, see
“Configuring the Initial Settings of the Two Projectors” (page E-8) in this manual.
Inverse Installation Vertical Installation
Use four M4 screws to fasten the bottom of the
cabinet to the ceiling mount bracket.
Use four M4 screws to fasten the left side of the
cabinet to the ceiling mount bracket.
M4 screws
M4 screws
M4 screw installation positions
<A>