Filter
Top Products
E-9
Getting Ready
7. On the remote controller, press the [MENU] key to display the setup menu, and then
configure the settings below in the indicated sequence.
z If the Projector System will be used in an inverted ceiling mount configuration, select “On” for the
“Screen Settings
3
Ceiling Mount” setting.
z If the Projector System will be used in a rear projection (projecting from behind the screen)
configuration, select “Rear” for the “Screen Settings
3
Projection Mode” setting.
z If the Projector System will be used in a location at an elevation of 1,500 to 2,000 meters, select
“On” for the “Option Settings 2
3
High Altitude” setting.
8. Press the [P] (Power) key twice to turn off Projector A.
9. Unplug the power cord of Projector A from the power outlet and plug in Projector B.
10.
Repeat the above steps 2 through 8 on Projector B.
11.
Plug the power cord of Projector A into the power outlet.
Setting Item Setting
(1) Option Settings 1
3
Auto Keystone Correction Off
(2) Screen Settings
3
Keystone Correction 0
(3) Screen Settings
3
No Signal Screen Black
(4) Input Settings
3
Signal Name Indicator Off
(5) Option Settings 1
3
Auto Power Off Off