Filter
Top Products
SA-500-27 14 Installation and Operating Instructions Page 9 of 12
CP5015A 09/09/08
MICROPHONE (PA Override)
The attached noise-canceling microphone is used for public address operation and overrides any
siren tone when push-to-talk button on the side of the microphone is pressed.
PA VOLUME CONTROL
With the vehicle parked, set the PA volume to the maximum level
with no feedback (squeal).
RADIO VOLUME CONTROL
With the vehicle parked and the radio volume itself set to a nor-
mal level, set the siren radio volume to the desired level.
AUXILIARY INPUT
During installation an auxiliary input may be connected to the horn ring or other switching device.
It provides the same operation as pressing the Horn button or optionally the Manual button.
See OPTION SWITCHES section for further details.
CUTOUT INPUT
During installation, a cutout input may be connected to a door switch. It turns off any siren tone
when the door is opened. The siren tone will continue to be cut off even when the door is closed.
Changing any switch on the face of the unit will restore normal function.
HORN RING CYCLER 2 (HRC2)
During installation, the auxiliary input must be connected and the HRC2 option selected. While
the siren is in standby, tap the horn ring to bring the unit out of standby into Mechanical tone.
Repeatedly tapping the horn ring will cycle through Mechanical, Wail, Yelp, and Phaser tones.
Tapping the horn ring twice quickly will stop the siren tones and return the unit to standby. Press-
ing and holding the horn ring will produce Horn tone until released. Then the siren will return to its
previous siren tone or standby.
See OPTION SWITCHES section for further details.
VOLUME
RAD PA
H L H L