Filter
Top Products
11
1.
MUTE (On Remote Control)
:
Mutes all output from the PS2000 Digital.
Press this button once to mute. Press a second time to restore audio output. You
can also enable or disable the mute function by pressing both volume buttons on
the Dipole Unit together.
2.
POWER ON/OFF (On Subwoofer)
: The POWER button on the Subwoofer
controls the power supply input from the Power Adapter. This button must be
depressed to activate the Dipole Unit.
3.
POWER (On Remote Control)
:
The POWER button on the Remote Control
and Dipole Unit sets the system to power on and standby mode. When the system
is turned on for the first time, the default input mode is “Digital” and the effects
selection is “Prism”. Subsequently, when the system is turned on from standby
mode, the last input mode and effect selection is retained.
4.
VOLUME (On Dipole Unit)
:
Adjusts the volume of the entire system. Press
the UP or DOWN button to increase or decrease the volume. (This function is also
available on the Remote Control, use the + or - button)
5.
DIGITAL
(On Remote Control)
: Selects the digital input source signal for the
OPTICAL or COAXIAL input. Digital input is the default mode when the system
is turned on. Optical input has priority. This button is located on the Remote
Control. (This function is also available on the Dipole Unit, use the SOURCE
button) The possible digital input signals are; PCM, 2-Ch AC-3 or 5.1 AC-3.
These signals are auto-detected.
PCM 2-Ch AC-3 5.1 AC-3
System Functions
PS2000 Digital_UK.book Page 11 Thursday, August 3, 2000 10:53 AM