Filter
Top Products
14 Incognito multi-room
PLANNING YOUR SYSTEM
When iinstalling yyour IIncognito mmulti-rroom eentertainment ssystem,
consideration sshould bbe ggiven tto ddetai
led aadvance pplanning. WWe
strongly ssuggest yyou rread tthis eentire mmanual bbefore ccommencing
any wwork.
AH10 AA-BBUS audio hhub
The AH10 is located alongside source components which means
you have two AH10 location options:
1. Locate AH10 and source components in any convenient discreet
location with adequate ventilation within the home (such as an
under-stair cupboard, service room or cabinet), or...
2. If it is desired to use the same sources for the Incognito system as
are being used by a conventional stereo or surround sound system
it is possible to route source equipment through the AH10 for
output through existing hi-fi or home cinema amplifiers whilst also
distributing them to the rest of your home via the Incognito system.
Should this be required, your existing audio source equipment
would be first connected to the AH10 and then routed from the six
loop out sockets on the AH10 to the amplifier/receiver in your
system via high quality audio interconnect cable terminated at each
end by phono/RCA plugs.
Similarly video source equipment may be connected to the VH10
and then routed from the six loop out sockets on the VH10 to the AV
receiver in a home cinema setup using phono/RCA cables designed
for video use.
For this configuration the AH10 should be located behind your
existing system.
It is suggested that you locate keypads:
••
138cm height from the floor finish (to centre
of keypad) or taking into account light switch
locations etc
••
25-35cm away from the outer edge of any
door frame or wall edge
••
Away from direct, bright sunlight which may
affect infra-red performance
AH10 location is critical
See opposite for details
In a bedroom it is suggested that you locate
speakers above or close to bed location for
optimal stereo reproduction
Locate speakers in all
rooms taking into account
location of furnishings for
optimal stereo reproduction