MONO BRIDGING MULTIPLE PAIRS OF AMPLIFIERS
2 OR MORE AMPLIFIERS WITH SEPARATE SPEAKERS
IMPORTANT:
Note the reverse speaker phase on 2nd amplifier
IMPORTANT:
Reverse the speaker phase on every alternate amplifier
NOTES ON MULTIPLE AMPLIFIERS AND SPEAKER PHASE
SYSTEMS WITH MULTIPLE AMPLIFIERS 11
Mode switch
Mode switch
1 ohm
minimum
1 ohm
minimum
Mode switch
Mode switch
Mode switch
Mode switch
2 ohm
minimum
To the Slave In of the next amplifier pair
To the Slave In of the next amplifier
2 ohm
minimum
BURST
LEVEL
FULL POWER
FULL
POWER
-50 dB
POWER
PRPR
BATTERY
VOLTAGE
BURST
LEVEL
FULL POWER
FULL
POWER
-50 dB
POWER
PRPR
BATTERY
VOLTAGE
MONOBRIDGING MULTIPLE PAIRS OF AMPLIFIERS
2 OR MORE AMPLIFIERS WITH SEPARATE SPEAKERS ON EACH
AMPLIFIER MODE SWITCH, INPUTS AND REMOTE CONTROL
The phase of each monobridged speaker per amplifier pair is the same. See the diagram on
the right.
Please note that for this type of setup, the speaker phase on every alternate amplfier MUST
be reversed in order to keep the acoustical phase of all speakers in the system in phase with
each other. See the diagram below.
The first, or master amplifier switch in these arrangements will of course act as the master in
all respects. It will accept the input from the source via RCA cables, and its level control,
crossover and filters, as well as remote control, if connected, will control all slaves. Do not
forget to set the amplifier Mode switches as indicated on all diagrams.
IMPORTANT:
Link between 2 amplifier - speaker terminals
#14 minimum
IMPORTANT:
Link between 2 amplifier - speaker terminals
#14 minimum
Boom
!
Harder
Pm2
Cable
Pm2
Cable
Pm2
Cable
Pm2
Cable
Pm2
Cable