Bush Hog GHM 1900 Satellite Radio User Manual


 
D. Attach PTO driveline to tractor 540 rpm or
1000 rpm PTO shaft. Make certain driveline is
securely connected at both ends. Attach PTO drive-
line shield safety chain on both the implement and
tractor ends. (Figure 2-3)
CAUTION
DO NOT USE A PTO SHAFT ADAPTER WITH THIS
IMPLEMENT. USE OF A PTO SHAFT ADAPTER
WILL VOID ALL WARRANTY CONSIDERATIONS.
E. Pin parking stand in work position. (Figure 2-4)
F. Adjust tractor lower lift arms so vertical main
frame is perpendicular to the ground as shown in
Figure 2-5.
G. Set tractor 3-point hitch depth control or install
the optional check chain assembly to stop with the
horizontal main frame pivot approximately 20 inches
from the ground. (Figure 2-4)
Figure 2-3
Fasten Shield Safety
Chains At Each End
Figure 2-4
Parking Stand Stored
20”
Ground
H. Check to be certain all persons are clear of
cutter bar.
I. Raise mower using tractor 3-point lift. Raise
cutter bar to transport position. When cylinder “bot-
toms out” hold valve open an additional 3-5 seconds
to purge air from system.
J. Pin transport lock to retain cutter bar in the
transport position. (Figure 2-6)
Figure 2-5
Figure 2-6 Transport Lock
90°
Ground
9