Care and Maintenance
10
English
Français Español
Cleaning
Scheduled cleaning is not required. However, you can simply wipe the outside surface
of the headphones with a dry cloth, as needed. Also, be sure that the earcup ports are
clear and that no moisture is allowed into the earcups. Use only a dry cloth to clean
the electrical contacts on the battery, in the charger, or in the battery compartment of
the headphones.
CAUTIONS:
• Be sure to unplug the battery charger before cleaning it.
• DO NOT use a moist cloth to clean the electrical contacts on the battery, in the
charger, or in the battery compartment of the headphones.
Troubleshooting
If you experience any trouble using your headphones, try the instructions in the
following table. If you still need help, call for technical assistance. In the United States
only, call 1-800-905-2180. For other regions, see the contact information on the inside
back cover.
Problem What to do
No noise reduction • Make sure the headphones power switch is on.
• Charge the battery.
Low or no volume • Make sure the audio source is on and the volume is turned up.
• Do not use the dual-plug adapter.
• Check the headphones cord connection at the source and the
earcup.
Crackling noise;
intermittent loss of
noise reduction
• Charge the battery.
• Clean the contacts on the battery and in the battery
compartment. See “Cleaning” on page 10.
• Replace the battery.
Low rumbling
sound
• Adjust earcup fit on your ears.
• Make sure earcup ports are not blocked.
Charger indicator
is flashing
• Remove the battery, wait 10 seconds, and insert it again.
• Unplug the charger, wait 10 seconds, and plug it in again.
• Make sure the air temperature is within the acceptable range
for charging, 32°F (0°C) to 95°F (35°C).
• Replace the battery.
• Replace the charger.
Short battery life
after charging
• Replace the battery.
• Replace the charger.
01.ENG_QC3.fm Page 10 Thursday, March 16, 2006 4:49 PM