Filter
Top Products
38
English
Reference
Changing the house code settings
Each LIFESTYLE
®
remote control uses a system of matching house codes to communicate
with its corresponding media center. If commands given from your remote ever conflict with
those of another nearby LIFESTYLE
®
system, you can easily set a new house code for your
system and its remote control(s) by doing the following:
1. Open the remote control battery cover and locate the miniature switches (Figure 15).
2. Move one or more of switches 1, 2, 3, or 4 in the opposite direction from its current
setting. Use a paper clip, ball point pen, or similar object.
Note: DO NOT change any other switch settings. Moving other switches may cause your
remote to not control your system.
3. Replace the battery cover.
4. Lift the media center door and press the All Off button.
5. Press and hold the Store key. Your current house code will appear in the media center
display window in the form of four rectangles which represent the positions of switches 1
through 4:
6. While holding the Store key, press any key on the remote control.
The display will change to show the new house code to confirm recognition of the
new code:
7. Release the Store key. The system remains off.
8. If you have additional remote controls, change the switches to match those of the first
remote control. It is not necessary to repeat steps 4-8.
Note: To verify your system’s house code, press Store while the system is off. The display
confirms the settings of switches 1-4.
Figure 15
Miniature house code
switches
HOUSE CODE:
Current house code = 0 0 0 0 (Switches 1 - 4 down.)
NEW HOUSE CODE:
New house code = 1 0 1 0
(Switch 1 up, 2 down, 3 up, and 4 down.)
123456789
123456789
House code switches (1-4).
Shown as set at the factory:
all switches down.