Filter
Top Products
SYSTEM SETUP
15
SYSTEM SETUP
English FrançaisEspañol
4. Press the TV source button. Only the TV source button will remain lit.
5. On the remote keypad, enter the first device code for your brand of TV.
6. Check that the TV source button blinks twice and turns off after the code is entered.
7. Point the remote at your TV and press TV On-Off. If your TV does not respond, go back
to Step 1 and try another code.
Follow the same procedure for each of your other sources, using the appropriate device code
and source button for each source.
Note: During programming, the five source buttons will flash rapidly three times if you press an
invalid key or enter an unavailable device code. If this happens, go back to Step 1 and start over.
To control a combination device
• If you are programming the remote to control a combination device that has more than one
source, such as a VCR/DVD unit, you can program the combination code into either remote
control source. You may find it convenient to program the code twice – once for the VCR
and once for the DVD.
• To find the right device code, first search the “COMBINATION” listings in the CineMate™
device codes book. If you cannot find a valid code there, then search the listings for
individual device types (TV, CBL, VCR, DVD, etc.).
Note: If you need to verify which device code is currently programmed in your remote, see
“Verifying a device code” on page 21.
TV source
button
05.Setup.fm Page 15 Tuesday, May 31, 2005 2:56 PM